How do you connect 1/4 irrigation tubing to 1 2 irrigation tubing?
Punch a hole in your 1/2″ or larger mainline tubing with one of our punches specially designed to ensure an accurate size hole. Insert one end of the 1/4″ barbed fitting into the end of the 1/4″ micro tubing and once complete, insert the other barbed end of the fitting into the punched hole in the 1/2″ mainline tubing.
Do drip tape emitters up or down?
A. Drip tape can be installed above ground, covered with mulch or buried (often called sub-surface irrigation). Whichever way you choose to install your drip tape please ensure the emitters face up. This reduces clogging caused by sucking in of dirt and debris at shut-down.
What are the numbers on compression tubing fittings?
Unlike the simple barbed ones, compression fittings are marked with two numbers, and both the ID and OD markings of the tubes must match the fitting. Thankfully, both the tubing and fitting types is standardized, so you are left to choose from the earlier mentioned 10/13, 10/16, 12/16 and 13/19 sizes.
What kind of tubing do I need for my hot water heater?
Same as for the soft tubing and other water cooling components, you cannot pick up just any random hard tubes from the flea market. The tubes you use must exactly match 12 or 16mm outer diameter (or the diameter set by the fitting you bought), because if leaks can occur, your components may be harmed.
What are the different sizes of soft tubing fittings?
Thankfully, both the tubing and fitting types are standardized, so you are able to choose from 10/13, 10/16, and 12/16 sizes of soft tubing compression fittings. A soft tubing compression fitting ( STC) consists of two parts, the main part is the base and it’s very similar to the standard barb fitting, but it has an additional thread.
How to invert backcheck valve on IV tubing?
Invert backcheck valve and ports as the fluid passes through the tubing. Tap gently to remove air and to fill with fluid. Inverting and tapping the access ports and backcheck valve helps displace and remove air when priming the IV tubing. 12. Once IV tubing is primed, check the entire length of tubing to ensure no air bubbles are present.
What do you use to hold counter top together?
Temporarily bolt the two corner pieces together from below. Use the special miter bolts (above) that come with the countertop. These special miter bolts temporarily hold the countertop corners together. Before ordering new countertops, you’ll need to make accurate measurements of your cabinet layout.
What’s the best way to install a counter top?
If your sink or range top didn’t come with a template, set the item upside down on top of the new countertop. Center it and trace the outline. Trace a band 1/2 inch around the edge on the inside of the outline.
What kind of Screws do I need to install a countertop?
Screw the build-up strips to the tops of your cabinets (sides and along the back) using 1-1/4 in. drywall screws. You may not need them on the cabinet end where the manufacturer has installed a finished end.
What should the overhang be on a laminate countertop?
When you measure for your countertop, be sure to include the counter overhang, which is usually between 3/4 to 1-inch in front of the cabinet face and on open ends. Plan to run the countertop flush with the cabinet sides or filler strip wherever a cabinet touches or leans against an appliance.
