How do you clean an igniter?
Use the toothbrush and a paste of baking soda and water or a 50/50 vinegar solution to clean the surface of the igniter. Avoid cleaners with bleach, ammonia or any other chemical that could produce noxious fumes. If you have to chip material off it, use a plastic toothpick or kitchen knife.
Can you clean a flame sensor rod?
CLEAN THE SENSOR Next, get a very light grain sandpaper, a wire brush, or steel wool. Use this to rub the metal rod gently, and only the metal rod, to clean the dirty flame sensor. You’re not sanding down a rusty car, here; you’re just trying to get rid of grit and buildup on the sensor.
How do you clean a hot surface ignitor?
Compressed air can also clean a blocked pilot tube that is causing the pilot flame to burn weakly or not at all. Simply point the applicator directly at the pilot orifice and blast away. It is possible to physically clean the probe on a hot surface ignitor.
How do you remove an ignitor from a furnace?
To do this, switch off power to the furnace either by turning off the wall switch or turning off the breaker in the main panel that controls the furnace. Disconnect the ignitor by pulling off the wires, loosen the screw holding the ignitor in place and gently lift it out.
Where can I find an AO Smith nitride ignitor?
Try Business Prime free. Water Heater Nitride Ignitor and Flame Sensor Assembly for AO Smith part number 9003626005. 5 Connection Molex Plug. Metal mounting Bracket.
How to clean a furnace flame rod sensor?
Once you have removed the sensor, gently rub the metal rod (only) with soft steel wool or soft scotch brie type pad NEVER USE SANDPAPER as it will damage the flame rod. Remember, you are not sanding down an auto body, but simply ridding the sensor of any build up it may have. Then, use a clean paper towel to wipe clean any dust left behind .
What’s the best way to clean an igniter?
Use the toothbrush and a paste of baking soda and water or a 50/50 vinegar solution to clean the surface of the igniter. Avoid cleaners with bleach, ammonia or any other chemical that could produce noxious fumes.
Once you have removed the sensor, gently rub the metal rod (only) with soft steel wool or soft scotch brie type pad NEVER USE SANDPAPER as it will damage the flame rod. Remember, you are not sanding down an auto body, but simply ridding the sensor of any build up it may have. Then, use a clean paper towel to wipe clean any dust left behind .
Try Business Prime free. Water Heater Nitride Ignitor and Flame Sensor Assembly for AO Smith part number 9003626005. 5 Connection Molex Plug. Metal mounting Bracket.
To do this, switch off power to the furnace either by turning off the wall switch or turning off the breaker in the main panel that controls the furnace. Disconnect the ignitor by pulling off the wires, loosen the screw holding the ignitor in place and gently lift it out.
