How do you change a Kohler Kitchen sink faucet?
If your faucet has a side spray for a kitchen sink, disconnect this line as well. Loosen and remove the compression fittings on the sides of the valves holding the lines in place with an adjustable wrench. Set the water lines aside. Disconnect the supply lines leading from the main plumbing valves that feed water to the faucet.
How do you change the gasket on a bathroom faucet?
Loosen and remove the nut, then pull out the stem cartridge. Most models have one or two O-ring gaskets on the cartridge. Cut off the old ones and push on new ones, or buy a new stem cartridge with new gaskets already installed to replace the old one. Based outside Atlanta, Ga., Shala Munroe has been writing and copy editing since 1995.
What to do if your Kohler Kitchen Sink washer is faulty?
Shut off the water to the faucet at the valves below the sink. Turn on the faucet to drain the water lines. Sponge up any water on or around the counter that may have come from the faulty washer. Disconnect the water lines that lead from the faucet valve or valves to the faucet spout.
How do you replace the handle on a bathroom faucet?
If your bathroom faucet has one handle in the middle instead of two knobs, the repair is similar. Pop off the cap and remove the top screw, then pull off the handle. Loosen and remove the nut, then pull out the stem cartridge. Most models have one or two O-ring gaskets on the cartridge. Cut off the old ones and push on new ones,…
How do you remove a valve from a Kohler faucet?
Remove this to remove the valve, but save it for use after the new valve is installed. Use an adjustable or fixed wrench, or a 5/8 inch deep socket wrench, to loosen the valve by turning it counterclockwise (Fig. 3). Remove the valve (Fig. 4). Install the new valve by screwing it back into the faucet, turning clockwise.
Loosen and remove the nut, then pull out the stem cartridge. Most models have one or two O-ring gaskets on the cartridge. Cut off the old ones and push on new ones, or buy a new stem cartridge with new gaskets already installed to replace the old one. Based outside Atlanta, Ga., Shala Munroe has been writing and copy editing since 1995.
How do you replace a handle on a two handle faucet?
Remove the valve (Fig. 4). Install the new valve by screwing it back into the faucet, turning clockwise. Tighten the valve with the wrench to 1/8 to 1/4 turn past hand tight. Before reassembling the handle, turn the water back on to check for leaks. Once you have made sure there are no leaks, reassemble the remaining parts. Fig. 1 Fig. 2
How do you fix a leak in a bathroom faucet?
The repair is a simple one in most cases. Turn off the water under the sink by rotating the hot and cold water shutoff valves clockwise as far as possible. Pop the center cap off the knob closest to the leak, on the side of the faucet where you see the most water pooling, using a flat-head screwdriver.
