How do you adjust a flushmate Actuator?

How do you adjust a flushmate Actuator?

The Actuator needs to be set at the proper clearance, 1/8” from either the Flush Rod or push button. To make this adjustment, hold the Actuator while loosening the Phillips setscrew in the center of the Actuator, and rotate the Actuator up (counterclockwise) or down (clockwise) until the proper clearance is obtained.

How do you adjust a flushmate tank?

How do you adjust a Sloan flushmate?

1. Make sure that the water supply valve is fully open.
2. Check for proper actuation adjustment, see Condition A-2, “Water runs and will not shut off.”
3. Turn off the water supply valve.
4. Flush the toilet to relieve the pressure.
5. Disconnect the water supply line from the Supply Shank (A). (

Should there be water in the tank with a flushmate?

FLUSHMATE units can emit a few drops of water inside the tank during the flushing cycle. This water collects on the bottom of the china until the water level reaches the height of the built-in drain. Normal level of water is about 1-inch.

What to do when your Flushmate won’t flush?

Reconnect the water supply line and fully open water supply valve. Check Air Inducer for sufficient air draw. Place a small amount of water (two to three drops) over the hole on top of the Air Inducer Cap (See Figure 14) and flush the toilet. If the Air Inducer is working properly, the water will be drawn in. (See Figure 15)

What causes no flush on a Sloan Flushmate?

Inadequate water pressure, an improperly adjusted Flush Valve Cartridge, a clogged inlet screen, or insufficient air draw may cause a weak, sluggish, or no flush condition. Make sure that the water supply valve is fully open. Check for proper actuation adjustment, see Condition A-2, “Water runs and will not shut off.”

What to do if your flushometer won’t stop flushing?

If the flushometer won’t stop flushing on your toilet, you can easily fix it by cleaning out the gasket. For a manual flushometer, first, take a flat screwdriver and turn the screwdriver slot that sticks out to one side, which will turn off the toilet’s water supply. Then, take a wrench and screw the top lid off the flushometer.

What should I do if my Flushmate tank is leaking?

Turn the Flush Valve Cartridge counterclockwise until you can lift it out of the FLUSHMATE® tank. Examine the exposed O-rings on the Flush Valve Cartridge for obstruction or damage. If the O-rings are damaged, the Flush Valve Cartridge should be replaced. Clean any debris from the O-ring before re-installing.