How do I unlock my Coleman hot tub?

How do I unlock my Coleman hot tub?

Unlock Operating Panel

1. Press the “Time” button on your hot tub operating panel.
2. Push the “Jets 1” button.
3. Push “Set down.” A “0” will appear on the screen indicating that the operating panel lock is off. The lock symbol will also disappear from the display on the operating panel.

How do I make my Coleman hot tub hotter?

How to speed up the heating?

1. Insulate the hot tub (cover it!)
2. Fill it with hot water (But be careful!)
3. Use a solar heater.
4. Use a wood-burning or gas water heater.

How do you unlock a Coleman hot tub?

Press the “Set up” or “Set down” button on your hot tub operating panel. Push the “Time” button. Press “Jets 1,” then “Set down.” A “0” will appear on the screen indicating the temperature control lock is off. The lock symbol will also disappear from the display on the operating panel.

Is there a way to reset the Coleman spa controls?

Sometimes, after you’ve set a custom setting, like a longer-than-default filtration period, you may want to revert back to the factory setting. You can do this by resetting the Coleman Spa controls. Set a custom filtration period.

What to do if your hot tub has an error code?

In some instances it may be more prudent to contact a local hot tub service company to assess and repair the spa pack as some diagnose procedures require special equipment. Please note that the Balboa Error Codes cover all circuit board manufactured by Balboa including Cal Spa, Marquis Spa, Master Spa and many others.

What does the code OH mean on a hot tub?

OH : Overheat. Spa temp over 108°. HLoH : Hi Limit Over Heat. Hi limit sensor is disconnected, shorted, or spa temp is above 112° F. SEoP : Sensor open or disconnected. Heater disabled but spa operational. SESH : Sensor short, nonfunctional. Heater disabled but spa operational.

Press the “Set up” or “Set down” button on your hot tub operating panel. Push the “Time” button. Press “Jets 1,” then “Set down.” A “0” will appear on the screen indicating the temperature control lock is off. The lock symbol will also disappear from the display on the operating panel.

How do I reset power to my Coleman spa?

Reset power to the spa. Do this by pressing the reset button on the GFCI (ground-fault circuit interrupter) or turning off power to the spa at the breaker. Check temperature and filter modes.

How can I troubleshoot my Coleman spa airlock?

Prime the airlock on the spa. Remove the access panel and open the bleeder valve. Close the valve when all air leaves the system. Open gate valves. These valves move water through the spa. Remove the access panel to ensure these are fully open. Daniella Lauren has worked with eHow and various new media sites as a freelance writer since 2009.

Are there error codes for digital hot tubs?

The best thing about digital spas and hot tubs – those with a spa side control panel – is that you are given error codes for most equipment problems. Spa error codes can be somewhat cryptic, but when you have the BIG LIST of CODES, you can immediately define the two or three digit source of trouble.