How do I change the pump Thetford cassette toilet C-402?

How do I change the pump Thetford cassette toilet C-402?

I squirted a bit of mouldew / bleach remover on the fan before replacing the pump in the tank. I also ran loads of water through the system to clean out any remaining bits of gunk that had obviously found their way in!

What to do if your cassette caravan toilet is not Flushing?

So try getting to the flush pump and free the impeller and replace the 3amp fuse. The only difficulty I had was getting at the pump. So don’t pull on the thin white electrical wire, instead grab the thick water flush hose that goes from pump to toilet and bring the pump up with that. When finished replace and check. Loading…

Where is the pump on a cassette toilet?

That seemed to loosen it up and it runs again. Thanks! the pump is located under the control panel. it sits in the holding tank for the flush water. you’ll feel a stiff hose about 3/4″ in diameter. its at the end of that hose. you’ll think youre going to break something but it will bend out thru the control panel hole.

I squirted a bit of mouldew / bleach remover on the fan before replacing the pump in the tank. I also ran loads of water through the system to clean out any remaining bits of gunk that had obviously found their way in!

So try getting to the flush pump and free the impeller and replace the 3amp fuse. The only difficulty I had was getting at the pump. So don’t pull on the thin white electrical wire, instead grab the thick water flush hose that goes from pump to toilet and bring the pump up with that. When finished replace and check. Loading…

What kind of water pump does a caravan use?

We aim to hold the most stock and have the fastest delivery on all caravan accessories and spare parts. This is a Genuine Thetford Cassette Pump to Suit C2, C400 & C200 CWE Cassette toilets. It is a commonly replaced spare part and the repair instructions for all 3 model toilets can be downloaded below.

That seemed to loosen it up and it runs again. Thanks! the pump is located under the control panel. it sits in the holding tank for the flush water. you’ll feel a stiff hose about 3/4″ in diameter. its at the end of that hose. you’ll think youre going to break something but it will bend out thru the control panel hole.

You Might Also Like