How do I bypass the safety switch on my electric heater?

Grasp the shut-off sensor with one hand and cut the wires going to the sensor with wire strippers. You will not be able to unplug the sensor as it is hard-wired. Strip the ends of the wires and twist them together. Twist a wire nut over the ends and replace the back panel.

How to troubleshoot a whirlpool energy smart water heater?

The Installation Instructions have a Diagnostic Code Chart and a Troubleshooting Chart you can use to identify and correct problems. If the LED light on the Control Board is not on, check to make sure the unit is getting electrical power. You can check for power with a simple “circuit tester” or volt meter.

How does the energy smart control board work?

The Energy Smart® Control Board has a flashing LED light which flashes trouble codes. The Installation Instructions have a Diagnostic Code Chart and a Troubleshooting Chart you can use to identify and correct problems.

What should the temperature be on a whirlpool water heater?

Water heater manufacturers recommend a temperature setting of no higher than 120ºF. Higher temperatures increase the risk of scalding injuries. Read and follow the temperature adjustment instructions and safety notices in the Installation Manual that came with your new water heater.