How do I add a hand held shower with a tub spout diverter valve?

How do I add a hand held shower with a tub spout diverter valve?

How to Add a Hand-Held Shower Using a Tub Spout Diverter Valve

1. Remove the Tub Spout. First, remove the old tub spout.
2. Install a New Spout. Purchase a new diverter-style tub spout that uses the same attachment method as the old one: slip-on or threaded.
3. Mount the Slide Bar.
4. Attach the Flexible Hose.

How to install a diverter valve for a shower?

Diverter Valve Installation Instructions from Delta. Shut off water supplies! Install the diverter so that the word “UP” (1) is facing upward as shown. Connect diverter to the desired valve. Remove plasterguard (2), bonnet (3), test cap and o-ring (4) prior to soldering. After soldering be sure to reinstall all parts.

How does an integrated diverter control work in a shower?

An integrated diverter control merges the mixing valve and trim kit, and the diverter valve and trim kit, into a single unit. Rather than having two separate valves to install, you’ll only have one. Instead of having two trim kits to install, you’ll also only have one.

Why do you need a hand held shower diverter?

Hand held shower is very helpful in maintenance — helps us keep shower clean and it means no mold and mildew. Always read manuals when installing valve on your own. Help of another person will be helpful also. I hope my video will help you at some point with your shower diverter valve and handheld project.

What kind of mixing valve do I need for my shower?

From the mixing valve outlet port, warm water runs in a pipe up into the diverter valve. We recommend choosing a Delta MultiChoice universal high flow (HF) mixing valve unless you plan to add a tub spout to your shower system (read more below).

How do you replace shower diverter?

The first step for replacing a shower faucet diverter is cutting out the old system. How’s this done without flooding the house! It begins with shutting off the water to the house and draining the water at the lowest point, e.g. laundry tub. Cut out the old faucet and attach shutoff valves to the existing pipes.

How do you replace a shower valve?

To replace a shower valve, start by unscrewing the shower handle and trim plate, so you can remove them. Then, shut the water off and cut a hole in the small opening behind the trim plate, so you can reach the valve. Using needlenose pliers , remove the valve clip and pull the valve out of the wall.

How does shower diverter valve work?

The diverter shower valve has nothing to do with the water temperature. It only controls where the water is flowing from in a shower/bathtub combination. The diverter valve usually pulls up, or that can be turned to shut off the water flow to the tub and divert it to the showerhead.

How do diverter valves work?

The diverter valve takes that compressed air and recycles it through the intake stream. If it had not diverted the air, the air would have caused the turbo to start spinning backwards as the air was sucked back into it. When your vehicle is tuned to recycle the air after the MAF sensor ,…