How big of a line do I need for a new toilet?
Make sure the valve is closed before you turn the water back on. If you’re connecting a new toilet to an existing stack, you only need to install the waste and supply lines. To do this, the toilet must be placed within 10 feet of the stack.
Can you put a sewer line under a toilet?
When sewer connections are located under the toilet, you have to allow room for pipes below the floor and then connect to the main sewer lines. However, if the sewer line connection is located in the wall itself, you can save space below the floor.
How much space do you need in front of the toilet?
Space in Front of the Toilet There’s also a minimum requirement for the amount of space that you need to keep free in front of your toilet. The latest building code says that 21 inches of space is required in front of every toilet and bidet. Toilet Paper Holder Location
What’s the best way to install a toliet line?
This is the soil stack and it should tie into the sewer with long sweep wye, or “Y”-shaped, fitting. Use a plastic wye if the sewer pipe is plastic, but if the sewer is cast iron, install a cast iron wye with a threaded inlet and screw on a PVC adapter. Glue the soil stack to the plastic wye or the adapter with PVC cement.
Make sure the valve is closed before you turn the water back on. If you’re connecting a new toilet to an existing stack, you only need to install the waste and supply lines. To do this, the toilet must be placed within 10 feet of the stack.
How do you install a water supply line for a toilet?
It should run from the tee to the wall behind the toilet and extend about 2 inches beyond the wall under the tank. Solder all the joints after you have assembled the supply line, and affix the line to a stud in the wall behind the toilet with a pipe clamp. 3. Terminate the water supply line with a shut off valve.
What kind of plumbing do you need for a toliet?
Glue 2-inch PVC pipe to the reducer and extend it through the roof. This pipe vents the toilet and should terminate 1 foot above the roof line. Choose an existing copper pipe that carries cold water near the toilet and shut off the water to that pipe.
Where are the water lines in a bathroom?
The center of the lav’s drain is located 18” (approximately) above the finished floor. Also notice the drain is centered right in the middle of this 30 inch vanity. The bathroom sink’s water lines are roughed-in 3 inches above the drain. Measure 21 inches (approximately) above the finished floor.
