Do you need building regs for new radiators?
Replacing a boiler or carrying out alterations to heating systems requires Building Regulations consent. So you won’t need to make a Building Regulations application unless your contractor isn’t registered with a self-certification scheme.
Will a new boiler make my radiators hotter?
A new boiler could be the secret to keeping a cold home warm, especially if it was installed more than 10 years ago. There are many more benefits that come with installing a new boiler too: A more comfortable temperature for your home. Higher level of efficiency.
Do you need a power flush when installing a new boiler?
If you are installing a brand-new boiler, then it is advised that you carry out the power flush before installation (if your existing system is very old), since you risk contaminating the new boiler with dirty water and debris that may cause damage.
Who qualifies for a central heating grant?
To qualify for a Central Heating Grant, you must own the property or be a private tenant and have bills, benefits, etc. registered at that address. Landlords and private tenants no longer qualify for boiler grants because it is the landlord’s responsibility to pay for these improvements.
Is the radiator on my new boiler working?
The new boiler is a Grant Vortex 90/120 ********* New boiler was installed yesterday and now 4/16 radiators not working. Two of the stone cold rads are upstairs, two are downstairs (a further two downstairs are lukewarm)
Do you have to put rads in boiler pipework?
The pressure will not be an issue, however increasing the heating load on the pipework may well be an issue and some of the pipework be undersized. You can put the biggest rads in you like but if the pipework can’t carry the volume of water required to make them perfrom then you are wasting money on the rads.
What to do when a new boiler is fitted?
I’m not a boiler fitter but i’m sure when you fit a new boiler the system needs to be cleaned before, otherwise it invalidates the boiler guarantee. Check the manufacturers instructions. Air in the system. Turn the hot radiators off at the lockshield or trv valves. This will force the cold ones to get hot. Vent the air from one in question.
How much does it cost to replace a RAD boiler?
3450 using old rads, one new one in the lounge, one in the bedroom cupboard and a towel rail. 20mm pipe all round replacing the microbore that was there before. The owner was thinking about not doing it, but the quote ended up being only 800 quid more, so he went for it. Copper piping as well.
What to do with an old radiator with a new boiler?
If installing hot water condensing boiler (any brand) with old radiator system, install a spiral trap on return. Very small investment on protection of $$ boiler. Forgot to put in there it’s a water system.
Why are my rads not working on my new boiler?
The Boiler guys reckons its just sludge in the system (it wasn’t affecting the rads before he installed the (condensing) boiler and he thinks flushing out the rads will work. I can’t understand why it could be the rads if;
I’m not a boiler fitter but i’m sure when you fit a new boiler the system needs to be cleaned before, otherwise it invalidates the boiler guarantee. Check the manufacturers instructions. Air in the system. Turn the hot radiators off at the lockshield or trv valves. This will force the cold ones to get hot. Vent the air from one in question.
Can a cast iron heater be used with a new boiler?
Cast iron radiators are a great source of heat. I would design the system to have constant circulation with trv valves that will allow you to adjust the temp in every room. Also put an indirect in with the new boiler,tankless heaters are inefficient and can cause problems down the line.
