Can you replace a submersible well pump yourself?

And there are special tools that contractors have to lift the pump from that kind of depth. Look at it this way: Even if you have someone else pull the well, you can do the repair/replace action on your own once it’s out of the ground, and still save money. 😉 My well was dug about 25 years ago.

How do you remove a submersible well pump?

Again, this work is best left to professionals.

Step 1: Clear the Area. Shut off the breaker to the pump.
Step 2: Remove the Well Cap. Use a 3/4-inch socket and ratchet to remove the nuts from the cap on top of the casing.
Step 3: Connect the T-Handle Tool.
Step 4: Remove the Adapter.
Step 5: Pull the Pump.

Can I install my own well pump?

If you have a well that is 300′ or less in depth, there is no reason that you could not install your own pump system. Even deeper can be done, but it may require extra preparation and ability. You will need to use some sort of lifting mechanism to control lowering the pipe into the well.

How do you install a submersible well pump?

You will also need 6 stainless steel cable clamps, use 3 at each end. Now you are ready to install your new pump. You do not need to tape the cable to the water pipe, but you can. Place the pump near the hole and move the water flex pipe so it is in a straight line to the well head.

Can a jet pump be used in a submersible well?

Residential and commercial, submersible and above ground, Jet Pumps, etc. If your water is really dirty or muddy, we can usually fix that by raising the depth of the pump in your well. We have all controls, holding tanks, meters, filters and water treatment equipment. We now have salt-free softeners.

When do you need a new well pump?

The heart of your well system is the well pump. If the water is close to the surface, you may have a shallow well driven by a jet pump, and if your water is over 25 feet (7.63 m) deep, you may have a submersible pump system. If the pump breaks, you may have to install a new pump.

How long does a submersible pump usually last?

Cheap contractor jobs usually fail within 2 years. Our philosophy is pay a little extra and it make it last 20-30 years, as our pumps do when a well water system is properly sized and installed correctly. Your new Expert Express system will last on average 25 to 40 years.

How do you shut off a submersible well pump?

Connect a hose to the hose connection at the bladder tank, turn on, and shut off the water going to the house. Turn the breaker on to the pump. Your water should gurgle, this sound is what happens when air is being pushed around. If you do not have water after 5 minutes; shut off the breaker to the pump.

What should I do before installing a shallow well pump?

Before you start to install a shallow well pump, cover the well to keep foreign objects from getting into the well, where they could contaminate the water or damage the system. Install the shallow well pump according to manufacturer’s directions. Be sure all pipe joints in the suction pipe are airtight and watertight.