Can you Repipe a house through the attic?
When running pipe from a slab to an attic, use cross-linked polyethylene tubing, or PEX, instead of copper. PEX is semi-flexible, which allows for long, continuous runs through joists and studs. Long runs reduce the need for tees, elbows and other fittings where leaks may occur.
Can you run water lines in an attic?
Running a water pipe through your attic is possible and actually much more common than you might expect. Depending on where you live and the climate that your home is exposed to, indoor attic piping may be the best and safest option for a property owner.
Can you reroute water pipes?
Rerouting pipes requires cutting into the pipes and capping off or repositioning the pipes in a new area. Rerouting pipes is often the go-to, more painless solution in the event of a slab leak. Walls, baseboard boxes, closets and ceilings are also viable places to route pipes with the proper insulation.
How to run a cold water line through an attic?
Insulation will help maintain water temperature levels in the pipes. Otherwise, a cold water line run a long distance through a hot attic can take several minutes to deliver cold water to a fixture. Use foam insulation that comes in sleeves and fits around the pipe. Run pipes as low as possible in the attic to allow access to heat from below.
What should I do if my plumbing runs through my attic?
If the pipes are run in a cold area, be sure to insulate inside the box. Insulate pipes run through an attic to reduce the risk of freezing. PEX pipe is resistant to bursting, but the fittings are not. Water inside the pipes can still freeze. Insulation will help maintain water temperature levels in the pipes.
Can a pipe be rerouted to the attic?
Pipes can be run underneath a floor or fixture that is especially hard to move or expensive to replace, such as cabinets, tile flooring or a bathtub. In these cases, rerouting the pipes overhead to the attic is an easier, less expensive alternative.
Can a water pipe be insulated in an attic?
Insulate water pipes run in an attic. When a water pipe leaks under a slab, it is necessary to jackhammer a hole in the slab to get to the damaged pipe. The leak can often be repaired by cutting out and replacing the damaged section of pipe, but sometimes the leak is especially difficult to access.
Insulation will help maintain water temperature levels in the pipes. Otherwise, a cold water line run a long distance through a hot attic can take several minutes to deliver cold water to a fixture. Use foam insulation that comes in sleeves and fits around the pipe. Run pipes as low as possible in the attic to allow access to heat from below.
Can you run water pipes from the outside to the attic?
Placing water pipes in outside walls greatly increases the risk of frozen and burst pipes in cold climates. When running pipes from a slab to an attic, use an inside wall. If no boards or beams run horizontally between the wall studs, the pipes can often be fed through the walls up to the attic.
How to fix under slab water line routing?
Maybe the proper fix for the under the slab routing of the water lines was to install 4″ diameter PVC piping under/through the slab that has all gradual turn corners. Through this can be pulled the PEX water lines. If ever a leak you can pull new lines through the PVC without digging up slab once again. – Michael Karas ♦ Nov 15 ’13 at 11:16
How to move plumbing pipes from slab to attic?
Use foam insulation that comes in sleeves and fits around the pipe. Run pipes as low as possible in the attic to allow access to heat from below. Close off or seal all cracks or gaps in the walls or attic in the vicinity of the pipes.
