Can you move toilet in bathroom?
Moving the toilet is not a change to be taken lightly. But if needed, it can be accomplished with substantial plumbing work and a great deal of peripheral work, such as opening up a floor or ceiling, rerouting pipes and drain flange, and re-installing the toilet and other fixtures.
Should I remove toilet for flooring?
Installation of new bathroom flooring requires removing the toilet. Installing new bathroom flooring requires removal of the toilet. Before removing the toilet, you will need to disconnect the water supply line, drain all the water and remove two nuts.
What happens when you move a toilet in a house?
Drainage: When moving the toilet, you will not be moving the home’s main drain/vent system, as this is shared by other drainage systems: bathing, other bathrooms, kitchen, etc. Instead, the individual line that goes from the toilet to that main stack with either be re-routed, shortened, or lengthened.
Can a toilet be moved away from the vent stack?
While usually this can be managed, it can limit the distance of the new toilet location, since the toilet needs to remain close enough to the vent stack or main drain to accommodate the necessary slope.
What’s the best way to install a new toilet?
Glue a 90-degree toilet bend onto the end of the new drain pipe, then glue a 6-inch length of pipe into the upward-facing socket, extending up through the floor. Continue the previous water supply line with a single run of PEX pipe through the joists.
What kind of fittings do you need to move a toilet?
For example, you will need to use PVC fittings if you are connecting to a PVC waste vent stack. Depending on where your toilet is being moved to, the precise drain fittings needed may vary. Be prepared use additional PVC or ABS fittings as necessary to route the toilet drain to the vent-waste stack.
Drainage: When moving the toilet, you will not be moving the home’s main drain/vent system, as this is shared by other drainage systems: bathing, other bathrooms, kitchen, etc. Instead, the individual line that goes from the toilet to that main stack with either be re-routed, shortened, or lengthened.
Glue a 90-degree toilet bend onto the end of the new drain pipe, then glue a 6-inch length of pipe into the upward-facing socket, extending up through the floor. Continue the previous water supply line with a single run of PEX pipe through the joists.
What should I use to remodel my bathroom?
Cement board is resistant to moisture and is a good backer for wall tile. Use drywall for other walls. Paint before the toilet, tub, tile, sink and vanity are installed to reduce the risk of splatter on new fixtures or flooring.
What kind of pipes do you need to move a toilet?
A relocated supply line might even tap into the existing toilet supply line and send it to the new location. Bendable plastic PEX pipes make this job easier for do-it-yourselfers than professional plumbers’ method of sweating copper pipes. Also, because water supply pipes are pressurized, there are no drainage issues.
