Can you drain a water softener into a floor drain?
A softener drain line must not be connected directly to the waste system, but must be emptied into a laundry tray, floor drain, or properly trapped special outlet, preserving an air gap of at least two times the diameter of the drain line, but in no case less than 1-1/2″ above the top of the receptacle used.
How do you drain a water softener?
Tip it upside down to drain out the water. Lay a piece of 2-inch thick board on the floor near a floor drain. Move the softener close to the floor drain. Slowly and carefully lay the softener over until the rim of the tank rests on the wood board with the inlet and outlet being over the drain.
Can a water softener drain outside?
If the total drop from the softener to the air gap is over 4 ft, yes. If if the air gap is outdoors, yes (to let the water drain out reliably so that it does not sit long enough to freeze).
How to install a water softener drain line?
To install a water softener drain pipeline, you need to know about the two lines. The first line of the drain is a valve made for disposing of the water during the regeneration process. After installing the first line of your water softener drain, you need to connect it with the other tube. The other drain line will connect with the brain tank.
Where does the water softener go in a water treatment system?
When the water treatment system is supplied with flexible drain line material, the drain must be tightly secured in the correct position to avoid deliberate or accidental movement. Some units provide an overflow drain line for the regenerant container. Such a line should be run to a floor drain. It must run by gravity feed to a lower drain.
Can a water softener be connected to a laundry sink?
Whenever there isn’t a way to connect to a laundry sink or into a floor drain you can use an Air Gap Fitting and drain over head to plumbing from above the install location. These Air Gap Fittings are plumbing code required whenever you hard plumb the drain line (waste line) of water treatment equipment to your household plumbing.
Can a drain trap be used for a water softener?
A trap installed in a waste line will also suffice, providing there is a proper air gap or vacuum breaker between the tap and the drain line from the softener. A funnel arrangement may also be advantageously used in such an installation.
Where can I install my water softener?
Where to Install the Water Softener. Location. Ideally, the water softener should be located where it’s easy to tie into the plumbing system, but out of the way. Usually, these locations include the basement, garage, utility room, or near the water heater.
Follow these steps to drain the softener: Turn off the water to the softener. Open a faucet at the kitchen sink or bathroom to vent pressure in the softener. If a single by-pass valve was used, move the stem to the by-pass. Unplug the transformer at the wall outlet.
Can I install a water softener system myself?
Yes you can. But, Discount Water Softeners always recommends having a licensed plumber install your water softener. If you have a basic understanding of plumbing and know how to sweat copper or work with PVC , you can install the water softener yourself.
How do I uninstall a water softener?
Turn off the water supply for the water softener that you wish to remove. In most installations, there should be a water supply valve which controls the supply to the softener, most likely near a wall or floor. Rotate the valve to the right to cut off the water supply.
