Can a universal thermocouple be used on a gas burner?
Yesterday, I replaced the thermocouple with a universal thermocouple and cleaned out the dust and soot from the burner area. After installation, I also did the detergent test to make sure the gas connections are secure and not leaking. I lighted the pilot and it appeared to work fine.
When does the pilot go out on a gas water heater?
The pilot in my gas water heater (Aquamax 205) has been going out sporadically over the last 2 weeks. Yesterday, I replaced the thermocouple with a universal thermocouple and cleaned out the dust and soot from the burner area.
Why does my gas water heater keep going out?
The pilot in my gas water heater (Aquamax 205) has been going out sporadically over the last 2 weeks. Yesterday, I replaced the thermocouple with a universal thermocouple and cleaned out the dust and soot from the burner area. After installation, I also did the detergent test to make sure the gas connections are secure and not leaking.
How do you change a thermocouple in a hot water heater?
How to Replace a Hot Water Heater Thermocouple Step 1: Familiarize Yourself with Your Water Heater Step 2: Access the Thermocouple Step 3: Release the Thermocouple Step 4: Install Replacement Thermocouple Step 5: Re-insert Burner Unit Step 6: Test Water Heater and Finish
Do all water heaters have a thermocouple?
Not all gas water heaters have a thermocouple. Some newer models have an advanced temperature control system. Essentially, it is a microprocessor that constantly monitors and controls burner operation and maintains consistent and accurate water temperature levels.
What does the thermocouple do on my water heater?
The thermocouple is part of the pilot burner assembly and connects to the gas control valve on the outside of the water heater. It is a simple device that converts the heat from a burning flame into a small electrical current , allowing it to work like a switch to control the flow of gas from the gas supply valve .
Where is the thermocouple on a hot water heater?
The thermocouple is attached to the water heater at two locations. The first location is at the underside of the gas valve. The thermocouple looks like a bare copper wire with a fitting on the end.
