Are tub drain holes standard size?
Down the Drain According to Bonnets Stems and Accessories, Inc., a standard modern bathtub drain is 1 1/2 inches in diameter – the width straight across the middle. Antique bathtubs, such as historic clawfoot tubs, sometimes have slightly smaller drain openings, often 1 3/8 inches in diameter.
What size should a bath waste pipe be?
32mm – for hand basin waste pipe. 40mm – for sink and bath waste pipe. 110mm – for soil pipe and main drains.
Can a standalone shower drain be used with a tub drain?
Standalone shower tub drains and a tub or bathtub and shower combination drain cannot be used interchangeably. If you are remodeling your bathroom and the project involves replacing your standalone shower with a tub, consider hiring a plumber to install the tub.
How do you replace a shower drain cover?
Loosen the bolts on the flange and place the shower drain cover in place, slotting it over the top of the bolts and turning it until it is locked in place. Tighten the bolts with your wrenches to finish the replacement.
How to fix a broken screw in a shower drain?
A more minimal approach (but you’ll need some creative clamping – perhaps a shaped wood scrap driven in) would be to glue in two short segments at 90 degrees from the present holes. You should be able to unscrew the closure from the top side without replacing the whole drain from beneath.
How do you replace a bathtub with a shower?
Remove any screws or nails securing the bathtub lip to the wall. With an assistant, tip up one side of the bathtub to remove it. You may need to remove a small portion of drywall (next to the tub area) to accommodate one of the outer corners of the tub as it swings upward. Thoroughly clean the demolished area, removing nails and screws from studs.
How to replace the drain cover in a shower?
Tips for removing and replacing the drain cover in a bathroom shower. To find a drain cover the right diameter and screw hole pattern I had to buy a 2″ ABS general purpose drain with stainless steel strainer. Please support my YouTube channel iScaper1 by using my Amazon Storefront to purchase products on Amazon. Loading…
How do you replace a tub drain lever?
Tub levers of the time closed the drain either by lifting a stopper with pressure from below or dropping a plunger into the pipe to block it off. A pop-up stopper has more moving pieces than a plunger; make sure you remove all the parts of the old apparatus before replacing it with a new one. Adjust the lever so the drain is open.
Do you have to pipe water from shower to tub?
Since a shower has a floor drain, waste water empties directly into the plumbing drain system. It does not have to be piped from the shower outlet to the plumbing drain system, like a tub drain requires.
Remove any screws or nails securing the bathtub lip to the wall. With an assistant, tip up one side of the bathtub to remove it. You may need to remove a small portion of drywall (next to the tub area) to accommodate one of the outer corners of the tub as it swings upward. Thoroughly clean the demolished area, removing nails and screws from studs.
