Are toilet valves universal?
Most are quite interchangeable and can fit the standard tank openings on any toilet, but do pay attention to sizes, especially the length of the valve stem. Many modern toilets have a rather small tank, and you’ll need to make sure the stem on the new fill valve is short enough.
How much does it cost to replace flush valve?
A simple toilet valve replacement typically costs $70 to $150. A complete rebuild of the closet tank which includes the flush handle, flush valve, flapper, ballcock, and tank bolts costs around $275.
What’s the best way to replace an old toilet?
Let’s get started by removing the old toilet. First, take off the lid to the tank and shut off the water. Drain the water out of the tank by holding down the flush lever. Then use a sponge or a towel to get the rest of the water out.
Why does my toilet water pressure go down after replacing the main?
If you have old pipes, rust can break loose after replacing the main and clog the screens in your sinks and toilets. I replaced mine, everything worked fine except both the toilets. Had to take them apart and clean them the next day. Thanks for contributing an answer to Home Improvement Stack Exchange!
How long does it take to change out a toilet?
Changing out your toilet is a project that will only take you a few hours. You may want to give your bathroom a new look with a new toilet. Or, you may need to fix a leak by replacing the wax ring. In either case, here I’ll show you how to replace a standard, two piece toilet with a tank that mounts on top of the bowl.
Why is my toilet still leaking after replacing washers?
I replaced all parts including washers. And still leak is there. I shut the water, drained the tank and poured into the tank just enough water to where it meets the flapper. Not touching the flapper just before it, and leak started until that small amount of water drained out. Please help
If you have old pipes, rust can break loose after replacing the main and clog the screens in your sinks and toilets. I replaced mine, everything worked fine except both the toilets. Had to take them apart and clean them the next day. Thanks for contributing an answer to Home Improvement Stack Exchange!
Why is water coming out of my bathroom sink?
2– The rubber sealing washer or o-ring may be squeezed excessively tight causing leakage. 3– The nut may not be tight enough and water is simply coming through. 4– The drain pipe is off center and therefore a tight seal is not possible. 5– The drain pipe is cracked and water is coming through the crack.
Why does my sink smell like sewer when I flush the toilet?
If there is a hole or crack in the plastic, replace the trap. Diagnose a venting problem by running water in the sink. Flush the closest toilet and listen for gurgling sounds coming from the sink. The sounds mean that the flow of water from the toilet is sucking air through the drain. Disconnect the trap and inspect the water level inside it.
How to fix drain pipe in bathroom sink?
4– Spin the nut all the way down or off of the threads. 5– Insert the drain back into the sink hole and be sure it is centered. 6– Install the nut and the sealing washer and tighten. (The excess putty will ooze out under the top flange until it is fully seated to the sink) 7– Remove the excess putty from in the sink.
